Gotomg

Specifications
Microprocessor
Microprocessor types
Select Intel® Core™ (dual core) processors
Intel® Pentium® 4 (single core) (with Hyper-Threading technology)
Intel® Pentium® D (dual core) (no Hyper-Threading technology)
Select Intel® Pentium® Extreme Edition processors (single or dual core) (with Hyper-Threading technology)
Cache
2MB or 4MB (depending on your configuration)
Memory
Type
533-MHz and 667-MHz ECC and non-ECC DDR2 SDRAM
NOTE: Ensure that you do not mix ECC and non-ECC memory.
NOTE: Your computer does not support registered or buffered memory.
Memory connectors
four
Memory capacities
512 MB, 1 GB, or 2 GB
Minimum memory
1 GB
Maximum memory
8 GB
BIOS address
F0000h
Computer Information
Chipset
Intel 975X
Data bus width
64 bits
Address bus width
32 bits
DMA channels
eight
Interrupt levels
24
BIOS chip (NVRAM)
8 Mb
Memory speed
533/667MHz
NIC
Integrated network interface with ASF 2.0 support as defined by DMTF
Capable of 10/100/1000-Mbps communication:
* Green — A good connection exists between a 10-Mbps network and the computer.
* Orange — A good connection exists between a 100-Mbps network and the computer.
* Yellow — A good connection exists between a 1000-Mbps (1-Gb) network and the computer.
* Off — The computer is not detecting a physical connection to the network.
SAS controller
add-in SAS 5iR card
System clock
800-MHz or 1066-MHz data rate (depending on your processor)
Video
Type
PCI Express x16 up to 150 W
Audio
Type
internal stereo: integrated HD audio or PCI option cards
Stereo conversion
24-bit analog-to-digital; 24-bit digital-to-analog
Controllers
Hard drive
integrated serial ATA (4), with RAID 0/1/5/10 and command queuing
integrated ATA-100 (1 channel)
Expansion Bus
Bus type
three PCI 2.2
one PCI Express x16 up to 150 W
one PCI Express x8, wired as x4
one PCI Express x1
eight USB 2.0 (2 front, 5 back, 1 internal)
Bus speed
PCI: 33 MHz
PCI Express:
x1 slot bidirectional speed - 500 MB/s
x 4 slot bidirectional speed - 2 GB/s
x16 slot bidirectional speed - 8 GB/s
Card slots
The upper five connector slots support full-length cards, and the connector slot at the bottom supports a half-length card.
NOTE: Check the documentation for cards to ensure that you can accommodate them in your configuration. Some cards that require more physical space and power (such as PCI Express graphics cards) may restrict the use of other cards.
PCI:
connectors
three
connector size
120 pins
connector data width (maximum)
32 bits
PCI Express:
connectors
one x1
connector size
36 pins
connector data width (maximum)
1 PCI Express lane
PCI Express:
connectors
one x4 full-length slot (supports x8, x4, and x1)
connector size
98 pins
connector data width (maximum)
4 PCI Express lanes
PCI Express:
connectors
one x16 slot (supports x16 and x1 modes/cards; x8 and x4 modes/cards are not supported)
connector size
164 pins
connector data width (maximum)
16 PCI Express lanes
Drives
Externally accessible:
one 3.5-inch drive bay (FlexBay) in desktop orientation, or two 3.5-inch drive bays (FlexBay) in tower orientation
two 5.25-inch bays
Available devices
serial ATA drive, SAS drive, floppy drive, Media Card Reader, USB memory devices, CD drive, CD-RW drive, DVD drive, DVD RW drive, and DVD and CD-RW combo drive
Internally accessible:
two 3.5-inch hard drive bays
Connectors
External connectors:
Serial
one 9-pin connector (optional 2nd connector); 16550C-compatible
Parallel
one 25-hole connector (bidirectional)
IEEE 1394a
one front-panel 6-pin serial connector (with optional card)
Video
VGA or DVI connector on graphic card
Network adapter
RJ45 connector
PS/2 (keyboard and mouse)
two 6-pin mini-DIN
USB
two front-panel, one internal, and five back-panel USB 2.0–compliant connectors
Audio
two rear connectors for line-in and line-out; two front-panel connectors for headphones and microphone
System board connectors:
Primary IDE drive
40-pin connector on PCI local bus
Serial ATA (4)
7-pin connector